EURO EN900C6 Manuel d'instructions télécharger pdf (Page 23)

Connecting the hob to the mains power supply

The power supply should be connected in compliance with the relevant

standard,or a single-pole circuit breaker.the method of connection is shown

below.

1. If the cable is damaged or needs replacing, this should be done by an

after-sales technician using the proper tools, so as to avoid any accidents.

2. If the appliance is being connected directly to the mains supply, an omnipolar

circuit breaker must be installed with a minimum gap of 3mm between the

contacts.

3. The installer must ensure that the correct electrical connection has been

made and that it complies with safety regulations.

4. The cable must not be bent or compressed.

5. The cable must be checked regularly and only replaced by a properly qualified

person.

1 2 ... 18 19 20 21 22 23 24

Pas de commentaire

EURO EN900C6 Manuel d'instructions Page 23